An international team of materials scientists from France, Russia and Kazakhstan found a way to boost the efficiency of organic solar cells several times. The new study, published in the Journal of Materials Chemistry A, has shown that ordered structures based on organic molecules can be used to produce solar power. For more information see the IDTechEx report on Distributed Generation: Minigrid Microgrid Zero Emission 2018-2038.
Solar panels, or batteries, are one of the most promising ways to generate electrical power. As of 2017, the combined power of solar panels installed worldwide amounted to 400 gigawatts. The solar power industry is experiencing a rapid growth, which depends on cheaper and more efficient batteries.
One way of improving solar power systems is by introducing new materials. The basic elements of a solar panel converting light into electricity are photovoltaic cells, or solar cells. They are mostly made of polysilicon — a highly pure polycrystalline form of silicon. But scientists are busy looking for alternative materials. Organic polymers with photovoltaic properties are one of the prime candidates to replace polysilicon.
A team of researchers from France (the University of Strasbourg, University of Lyon, Institut de Sciences des Matériaux de Mulhouse, Synchrotron SOLEIL), Russia (Moscow Institute of Physics and Technology, Moscow State University), and Kazakhstan (Nazarbayev University) has described a way of boosting the efficiency of organic solar cells by incorporating fluorine atoms in the polymer. This process, known as fluorination, was previously shown to enhance polymer photovoltaic properties, but the mechanism was poorly understood. The new study clarifies the effect of fluorination on cell efficiency.
By experimenting with various polymer modifications, the team increased cell efficiency from 3.7 to 10.2 percent. While this still falls short of the commercial silicon photovoltaics, the massive gain in efficiency suggests that polymer-based cells are a technology to be reckoned with. Perhaps with further tweaks organic solar cells could outperform their polysilicon-based counterparts.
The generic polymer used in the experiment has a rather complex molecular structure. It consists of a chain of repeating units shown in the left part of figure 1 above. Each of them includes sulfur heterocycles — rings made of one sulfur and four carbon atoms — and hydrocarbon side chains with a branched structure. The researchers produced a number of modifications of this polymer to find which one has better photovoltaic properties. They changed the structure by adding fluorine atoms (figure 1, right) and varying the length of the side chains.
One polymer configuration proved to result in vastly superior properties. Namely, the cell efficiency and current output were several times higher. The team then investigated the microscopic structure of the best-performing compound. X-ray analysis revealed polymer stacking to be more ordered. Also, the molecules were characterized by higher charge carrier mobility, which means the material conducts electricity better. For a solar cell, this is clearly an advantage.